Cirrus-logic CS5566 Bedienungsanleitung

Preliminary Product InformationThis document contains information for a new product.Cirrus Logic reserves the right to modify this product without not

CS556610 DS806PP25/4/09 DIGITAL CHARACTERISTICSTA = TMIN to TMAX; VL = 3.3V, ±5% or VL = 2.5V, ±5% or 1.8V, ±5%; VLR = 0V DIGITAL FILTER CHARACTERISTI

CS5566DS806PP2 115/4/09GUARANTEED LOGIC LEVELSTA=-40to+85°C;V1+=V2+=+2.5V, ±5%; V1- = V2- = -2.5 V, ±5%;VL - VLR = 3.3 V, ±5%, 2.5 V, ±5%, or 1.8 V, ±

CS556612 DS806PP25/4/09RECOMMENDED OPERATING CONDITIONS(VLR = 0V, see Note 17)17. The logic supply can be any value VL – VLR = +1.71 to +3.465 volts a

CS5566DS806PP2 135/4/092. OVERVIEWThe CS5566 is a 24-bit analog-to-digital converter capable of 5 kSps conversion rate. The device is ca-pable of swi

CS556614 DS806PP25/4/093.1 Converter OperationThe converter should be reset after the power supplies and voltage reference are stable.The CS5566 conv

CS5566DS806PP2 155/4/093.2 Power ConsumptionThe power consumption of the CS5566 converter is a function of the conversion rate. Figure 6 illustratest

CS556616 DS806PP25/4/093.3 ClockThe CS5566 can be operated from its internal oscillator or from an external master clock. The state ofMCLK determines

CS5566DS806PP2 175/4/093.5 Analog InputThe analog input of the converter is fully differential with a peak-to-peak input of 4.096 volts on each input

CS556618 DS806PP25/4/093.7 Typical Connection DiagramsThe following figure depicts the CS5566 powered from bipolar analog supplies, +2.5 V and - 2.5

CS5566DS806PP2 195/4/09The following figure depicts the CS5566 device powered from a single 5V analog supply. Figure 9. CS5566 Configured Using a Sin

CS55662 DS806PP25/4/09TABLE OF CONTENTS1. CHARACTERISTICS AND SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

CS556620 DS806PP25/4/093.8 AIN & VREF Sampling StructuresThe CS5566 uses on-chip buffers on the AIN+, AIN-, and the VREF+ inputs. Buffers provide

CS5566DS806PP2 215/4/09Figure 11 through Figure 16 illustrate the performance of the converter with various input signal magni-tudes. -180-160-140-1

CS556622 DS806PP25/4/09Figure 16 illustrates the device with a small signal 1/1,000,000 of full scale. The signal input for Figure 16is about 8.2 micr

CS5566DS806PP2 235/4/093.10 Digital Filter CharacteristicsThe digital filter is designed for fast settling, therefore it exhibits very little in-band

CS556624 DS806PP25/4/093.11 Serial PortThe serial port on the CS5566 can operate in two different modes: synchronous self clock (SSC) mode &synch

CS5566DS806PP2 255/4/093.12 Power Supplies & GroundingThe CS5566 can be configured to operate with its analog supply operating from 5V, or with i

CS556626 DS806PP25/4/094. PIN DESCRIPTIONS CS – Chip Select, Pin 1The Chip Select pin allows an external device to access the serial port. If SMODE =

CS5566DS806PP2 275/4/09BP/UP – Bipolar/Unipolar Select, Pin 11The BP/UP pin determines the span and the output coding of the converter. When set high

CS556628 DS806PP25/4/09SCLK – Serial Clock Input/Output, Pin 23The SMODE pin determines whether the SCLK signal is an input or an output signal. SCLK

CS5566DS806PP2 295/4/095. PACKAGE DIMENSIONSNotes: 1.“D” and “E1” are reference datums and do not included mold flash or protrusions, but do include

CS5566DS806PP2 35/4/09LIST OF FIGURESFigure 1. Converter Status . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

CS556630 DS806PP25/4/096. ORDERING INFORMATION 7. ENVIRONMENTAL, MANUFACTURING, & HANDLING INFORMATION* MSL (Moisture Sensitivity Level) as spec

CS55664 DS806PP25/4/091. CHARACTERISTICS AND SPECIFICATIONS• Min / Max characteristics and specifications are guaranteed over the specified operating

CS5566DS806PP2 55/4/09ANALOG CHARACTERISTICS (CONTINUED) TA = -40 to +85 °C; V1+ = V2+ = +2.5 V, ±5%; V1- = V2- = -2.5 V, ±5%; VL -VLR = 3.3 V, ±5%;

CS55666 DS806PP25/4/09SWITCHING CHARACTERISTICS TA= -40 to +85 °C; V1+ = V2+ = +2.5 V, ±5%; V1- = V2- = -2.5 V, ±5%;VL - VLR = 3.3 V, ±5%, 2.5 V, ±5%,

CS5566DS806PP2 75/4/09SWITCHING CHARACTERISTICS (CONTINUED) TA=-40to+85°C;V1+=V2+=+2.5V, ±5%; V1- = V2- = -2.5 V, ±5%;VL - VLR = 3.3 V, ±5%, 2.5 V, ±5

CS55668 DS806PP25/4/09SWITCHING CHARACTERISTICS (CONTINUED) TA=-40to+85°C;V1+=V2+=+2.5V, ±5%; V1- = V2- = -2.5 V, ±5%;VL - VLR = 3.3 V, ±5%, 2.5 V, ±5

CS5566DS806PP2 95/4/09SWITCHING CHARACTERISTICS (CONTINUED) TA=-40to+85°C;V1+=V2+=+2.5V, ±5%; V1- = V2- = -2.5 V, ±5%;VL - VLR = 3.3 V, ±5%, 2.5 V, ±5