Cirrus-logic AN271 Bedienungsanleitung Seite 1

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Cirrus-logic AN271 herunter. Cirrus Logic AN271 User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 5
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Copyright © Cirrus Logic, Inc. 2007
(All Rights Reserved)
http://www.cirrus.com
AN271
Cirrus Seismic Evaluation GUI Installation Guide
Cirrus Seismic Evaluation GUI (graphical user interface) is a generic tool controlling Cirrus Seismic Eval-
uation boards through a USB interface. The GUI can be obtained from www.cirrus.com/industrialsoftware
.
1. GUI Installation
1) Go to the Cirrus Industrial Software download web site (http://www.cirrus.com/industrialsoftware).
2) Click the link, “Cirrus Seismic Evaluation GUI Vxx” (xx indicates version number).
3) Download the file named SeismicEvalGUI_Vxx.zip onto the PC and unzip it. A folder structure called
“Distribution\Volume1” will be created (for example, C:\Distribution\Volume1)
4) Open the folder and run the setup.exe file (C:\Distribution\Volume1\setup.exe).
5) If the GUI has been installed previously, the Uninstall wizard will remove the older version (see below).
6) Follow the instructions presented by the Cirrus Seismic Evaluation Installation Wizard.
7) To run the GUI, go to:
Start
B
Programs
B
Cirrus Seismic Evaluation
B
Cirrus Seismic Evaluation
JAN ‘07
AN271REV3
Seitenansicht 0
1 2 3 4 5

Inhaltsverzeichnis

Seite 1 - 1. GUI Installation

Copyright © Cirrus Logic, Inc. 2007 (All Rights Reserved)http://www.cirrus.comAN271Cirrus Seismic Evaluation GUI Installation GuideCirrus Seismic Eval

Seite 2 - Installation

AN2712 AN271REV32. USBXpress® InstallationImportant: The USBXpress® driver must be installed prior to launching the Cirrus Seismic Evaluation GUI.The

Seite 3 - AN271REV3 3

AN271AN271REV3 37) The PC will install the USBXpress Device driver. 8) After installation, cycle the power to the target board.

Seite 4 - 10) To run the GUI, go to:

AN2714 AN271REV39) The PC should add the USBXpress Device under Universal Serial Bus controllers in Windows DeviceManager automatically. (See figure b

Seite 5 - AN271REV3 5

AN271AN271REV3 5Contacting Cirrus Logic Support For all product questions and inquiries contact a Cirrus Logic Sales Representative. To find the one

Kommentare zu diesen Handbüchern

Keine Kommentare